DECWRITER 500I DRIVER DOWNLOAD

If this is not respected there is danger that serious damage is caused to the print carriage and the protection rubber caps exchange kinematics. User Maintenance Color head cleaning and maintenance: To do so, grasp the head pulling it towards the rear and remove it from its position. The printer will start to feed the sheets and print the test. Refer to this manual when a fault has not been corrected using the recommendations described in the Installation and User Guide included with the printer.

Uploader: Bralrajas
Date Added: 17 May 2017
File Size: 66.78 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 14479
Price: Free* [*Free Regsitration Required]

DECwriter i DECcolorwriter ic Service Manual (LJ and LJ) |

The ink arrives at the corresponding nozzles through channels in the dedwriter layer of the head. Defwriter install the print head: If the printer is switched off during this reset, the print head may not stop in its rest position. To obtain the distance of 1.

To enlarge the LQ and emulation graphic fonts, the memory extension memory card must be inserted to handle the DLL functions Down Line Loading. Keeping the key pressed at machine power-on with paper present the bi-directional print alignment function is activated. Parts Replacement 9. The procedure to run this test is the same as for the monochrome head section 5.

To enable the ink reset, set the printer to local mode in this status the nozzles are aligned to the rubber cap connected to the ink discharge tube. To feed the paper from ASF2 it is necessary to select feeding from this option in the set-up parameters.

  GOVERNESS MOVIE MINNIE DRIVER DOWNLOAD

Printer: DEC DECWriter i | OpenPrinting – The Linux Foundation

The assignment of the codes included in the second ISO set table varies from country to country and from product to product. Nozzles are cleaned by the rubber wiper located at the right-hand end of the head stroke.

Rotate the motor anticlockwise so that the rear screw is against the right edge of its hole. The printer must be installed on a flat, steady surface. This printer can be connected to personal computers with a standard parallel or optional serial interface.

The printer will start to feed the sheets and print the test. The next page shows an example monochrome of the print test for the color head.

Refer to this manual when a fault has not been corrected using the recommendations described in the Installation and User Guide included with the printer. Diagnostics and Test 5. For correct head functioning, the above voltage must be stabilized. Mechanical Adjustments 7. Always switch off the printer before switching off the computer. Using a feeler gage, measure 1. This lever is only used to indicate the variation to the machine when a color head is installed.

  FORNAME ORG POSTGRESQL DRIVER

Disabling the Data Scope printout: Remove the ASF drawer from the machine Insert the sheets max.

DECwriter 500i DECcolorwriter 520ic Spare Parts & Options List

Summary This manual is divided into 9 chapters and 1 appendix which contains the list of recommended spares FRU. The ink, contained in a sponge cartridge, is connected to the nozzles via channels in the resin layer of the head.

Higher voltage may provoke excess bubble commands or the absence of command due to resistor deterioration. If the printer is not configured by the system, it will use the parameters set in the factory Default.

DECwriter 500i DECcolorwriter 520ic Service Manual (LJ500 and LJ520)

The nozzles are assembled on a Nickel and Gold composition called “electroformed”. If anything is missing or damaged, call your supplier immediately.

Check that the interface cable is the correct type and that it is not too long 2. The test supplies the following information: C5, DL, C 10 and C6 can be obtained from the table below.

Holding the cartridge by the grip, remove the protective label from the nozzles.