KONICA MINOLTA 7085/IP-602 DRIVER

Please refer to attached Error Codes list. Verify that the correct AC voltage is available to the machine. Repeat steps 4 through 6 until the amount of punching-resistance loop is correctly set. To increase the AC separation current, perform the following: When inputting the serial number use “GE” for the letter portion example: Touch [OK] on the lower right corner of the Copier initial setting screen. Remove the folding unit and thoroughly inspect the conveyance path to the folding stopper.

Uploader: Akir
Date Added: 22 November 2015
File Size: 11.35 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 7859
Price: Free* [*Free Regsitration Required]

An incorrect toner cartridge is installed. The Charge Corona Unit has failed. Check the RADF to ensure that it remains in the raised position when lifted from the platen glass. Under [Size], select [Wide Paper]. PS tray upper limit detection PS failed.

Konica Minolta /ip Driver | Konica Support

A modification is required for machines below serial number 56GE A failed firmware flash process, possibly caused by corrupt firmware files or a poor parallel cable connection between minotla PC and To set the fixing temperature switchover, perform the following: Solution The FS can staple a maximum of sheets. There are approximately 30 registers that can be corrupt, so the above procedure may have to be done as much as 30 times.

  DR BT10CX DRIVER DOWNLOAD

Power ON the IP Each pin should have 5V DC.

Paper will stop at the 2nd feed rollers with the copy, scan and interrupt buttons all flashing and the machine still running with a jam code indicated. The e-clip is detached and the shaft falls off. The following are alternate high temperature transparencies that are also minoolta Konica recommends feeding transparencies through the bypass tray to reduce the occurrence of misfeeding.

Shift the position of the TSL 3mm toward transfer corona side. Access the 47 multimode power ON the machine while holding down on the 4 and 7 keysinput code 60, press PP. It does not include the key counter PCUA Solution The model comes standard with an HD Item installed. Losing network settings after firmware upgrade. Use the arrows on the right to scroll to 1.

7085 – ALL ACTIVE SOLUTIONS June 2009

The file will print konlca. PS Original Reversal Detection failed. Code has several tests for the document feeders: Set the individual tray for Thick Paper mode.

  INTEL 537 DATA FAX V.92 MODEM DRIVER DOWNLOAD

June 12 Miscellaneous may have expired.

Solution To print the management lists, perform the following: Access the 47 multimode by holding the 4 and 7 keys while powering the machine ON, input code 76, press PP. FM1 Paper exit fan failed.

DriverHive Details for KONICA MINOLTA /IP PS Driver

Next, check CN pins on the power supply management board. Using the key pad on the touchscreen enter the desired value.

Incorrect setting of software dipswitch Folding, stapling and folding, trimmer faulty part isolation. Solution Site Requirements 20 and 30 Ampere Machines. Ensure that the wiring is secured in all clamps and position the wiring so there is no contact with the lower right side cover. The ADU registration roller and the loop roller failed.